TFB300 by XANTREX - TFB300

Installation Component for Inverters and Inverter/Charger Systems. Provides over-current protection for system wiring. For safe operation of your inverter or inverter/charger system, XantrexÕ Battery Fuse and Holder is a recommended accessory that offers over-current protection for the cable running between the inverter and battery power source. The Battery Fuse and Holder has a cover that protects from inadvertent contact with the battery fuse and posts, and the fuse is Class-T rated to allow for momentary surges without blowing. As current passes through any cable, heat is generated. If the inverter draws more current than the cable can handle due to heavy loads, excessive heat is produced. The fuse can handle a certain amount of excess current but is designed to blow when the safe limits are exceeded, protecting the cable from deterioration or permanent damage. Proper sizing of the cable and fuse are important in ensuring that these hazards are avoided. For specific recommendations, refer to the inverter or inverter/charger ownerÕs manual. Dimensions (HxWxD): 2.5 x 2.0 x 7.0Ó -- Weight: 1.5 lb -- Hardware: 3/8Ó

Xantrex tfb300, 300a Class t fuse and holder w/studs Use these single-pole Class t fuse blocks to fuse inverters or other large loads. a 5/16 stud mount at each end of the fuse allows connection of a cable with a ring lug terminal end. To connect an inverter, order two cables with lugs on both ends one to go from the battery to the fuse and one to go from the fuse to the inverter. Class t fuses exceed the 10,000-amp interrupting capacity aic required to protect Square-D brand circuit breakers in dc load centers. They are ul Listed for up to 160vdc and nec approved for inverter use. a fuse comes installed in the block. Order spare fuses separately. Xantrex tfb300, 300a fuse and holder w/studs