SIO 649X3PK2 @ KSCdirect Page 1

Directions - Step 1 - Cut tube off square (90°) with a tube cutter. Step 2 - Slide the PEX crimp ring over the end of the PEX tube leaving about ¼″ of the tube showing. Insert the fitting into the end of the tube. BE SURE the crimp ring is centered over the PEX barb. Slide the PEX sleeve over the end of the PEX tube fully. Insert the fitting into the end of the tube. BE SURE the fitting is inserted fully into the pipe. Step 3 - Center the jaws of the correct size crimp tool over the crimp ring or sleeve. Be sure the tool is held STRAIGHT and close the jaws completely. CRIMP/ PRESS ONE TIME ONLY! If you do not get a proper crimp connection the first time, cut the fitting off and start from the beginning. Step 4 - BE SURE TO CHECK EVERY CRIMP JOINT! Every crimp joint should be checked with the GO/NO GO Gauge. If the designated GO slot fits over and will rotate around the crimped ring, you have made a proper crimp. If the crimped ring will fit in the NO GO Gauge or will not fit in the GO Gauge, you must cut the crimp joint off and make a new connection.